To remove the anti-glare coating, make sure the screen is facing up. Keep this intact and just carefully flip the metal bezel up and lay it down above your panel on your workspace. The bottom will have a strip of foil tape that is lightly perforated In retrospect, it would have been easier to lay the panel down on it's face and just lift the housing off Alas, hindsight is 20/20 and this was my first time No harm done.Īll that's left is to remove the metal retainer bezel from around the panel which comes off easily by lightly prying the little pry-points up over their detents all around the housing. Pull the screen out of the rear housing by gently lifting it out. This allows you to set the front bezel completely aside. I chose to also unscrew the little menu control board from the bezel as it's only connected by a seemingly fragile ribbon cable. Carefully go around and pry the rest of the clips out, it gets easier with each clip. Next, pry up on the front plastic bezel from the inside (the side where the bezel touches the actual lcd) until one of the clips releases. Looking back, I'm glad I had some soft plastic pry bars to learn with.įirst, remove the 4 screws on the back of the monitor. Now that I know exactly how it's all assembled I could probably do it with nothing more than careful use of a a couple screwdrivers. Having never taken a monitor apart before, I did a lot of research first and made sure I had the right tools instead of trying to improvise. It's actually a lot easier than I thought it would be. I have cleaned it maybe 5-6 times total since the original mod. I do not clean the screen with anything other than compressed air and a very soft microfiber cloth with warm water and another dry one after, minimal pressure.
It has gone from Jersey to Tucson to Phoenix and sits on an articulating mount so it gets moved around quite a bit.
#DELL E207 REMOVE POLARIZER UPDATE#
UPDATE (0): Just want to check in and update that my screen is still 100% flaw free and working fine.
#DELL E207 REMOVE POLARIZER HOW TO#
How To Remove the Anti-Glare Coating from a Dell U2312HM Monitor
0 kommentar(er)
